On-Line Manual

Bookmarks

 

 

Client  Vehicle  Invoice  Accounts  Ledger  Parts  Orders  Utilities  Docket  Workshop 


The Conversion Table lists many conversions most likely required from time to time in the automotive field. The Conversion Table is very versatile allowing the user to change existing conversions and add new conversions if required.
   
To use the Conversion Table, select Utilities
from the Main Menu. Select Conversion Table from the drop down menu. Alternatively, use the Ctrl+T hotkey combination from the Main Menu. The Conversion Table is displayed.

Move about the conversion table by clicking on the fields, pressing the Tab
key or using the Alt+Hotkey combinations.

As you enter a figure, the corresponding conversion is calculated and displayed. Any conversion may be changed for new values and extra conversions may be added in the five blank entries. To edit the conversions select the Edit Entry control. The Conversion List is presented.

If you wish to change one of the current default conversions, select the conversion and click Ok. If you wish to add a new conversion, select one of the blank entries at the bottom of the list and click Ok. The
New Conversion edit dialogue is presented.

Enter the two units for the conversion. Unit 1 is presented in the left column of the conversion table. Unit 2 is presented in the right column of the table. Enter the multiplication factor in the Factor
field. Click Ok to save the new conversion Your new conversion is now displayed in the Conversion Table.
   
Select the Restore Defaults control to restore the conversion table to the original settings. This will remove any new conversions added to the table.

Tip:
The Conversion Table is capable of running independently of G-E so it can be always at hand. To do this, open the Conversion Table as above. Click anywhere on the screen outside the table. The table will shrink to the taskbar and run as a separate program. To close the table, click the Quit
control on the Conversion Table window.

Change Password

Backup
Restore
Rebuild Index
Send Backup to GE Systems 

Text Entry >
Kit >

Tax Information

Select Default Printer
Envelope Setup
Print Job Sheet

Conversion Table
Calculator
Graphics